How To Flash Your Sammy And Get The Au To Work!!!
HOW TO FLASH YOUR SAMMY PROPERLY AND GET THE AU TO DO ITS MAGIC!!! :clapping::thum:
[Remember: switch your Sammy off at the back BEFORE and AFTER you program the EMU in! Do not hurry, do not cut corners, if you want it all to work properly!]
After Sammy has cooled down a bit [say 5 - 10 minutes] switch it on at the back and keep it on Standby.
Now start the STUDIO 1.2 [or 1.3] by MAHDI and go to DSR FW Loader and Send FW, then choose the Emu you want to put in [in this case the excellent 5.9!] and Open -> to put the EMU in. Wait for the clock on Sammy display, do not rush!
When you start Sammy via a remote go to RESET EMU [again: via a remote] by pressing 0 + Menu quickly in succession, then go down to RESET TO EMU DEFAULTS and press the OK button on your remote.
(After it resets you can go back to EMU MENU to make sure you have the following configuration:
EMU - ON
EMM - ON
CAID Mode - AUTO
CS Mode - SSSP [if you need that one or HSIC if you're sharing via the Hummy CS SW]
EMU Active Mode - NO CARD [One doesn't need the Conax Card nowadays!])
Put Sammy to Standby and then kill at the back for a few minutes.
Restart your Sammy at the back, then leave it on Standby.
Now put the RAM in [Cruiser's are excellent!], if you need to, then start Sammy via remote.
==================================================
Now the AU function for D+, Premiere and TPS
Go to a channel in D+, for instance [I just did it on Taquila 7], then do the following...
[By the way, sometimes you will need to scan some transponders, as Sammy likes to "see all the data" for himself - only then can you see some transponders/channels - if you put in somebody else's settings, like Cuorino's good work!]
Go to EMU Menu, where you should have:
EMU - ON
EMM - ON
CAID Mode - AUTO
CS Mode - SSSP [if you need that one or HSIC if you're sharing via the Hummy CS SW]
EMU Active Mode - NO CARD [One doesn't need the Conax Card nowadays!]
Now do the EMU RESET, as described above, by pressing 0 + Menu quickly in succession, then go to RESET TO EMU DEFAULTS and OK.
Wait a little bit - it's fast to AU on all 3 providers!
Once you have the pretty colours go to the next of the 3 big publicly hacked providers [a channel of your choice]. Put your Sammy to Standby, then re-start it. Repeat the EMU Menu Reset to AU.
It should AU, provided you scanned the transponder on which you wanna AU.
Just flashed the receiver with 5.9 and tested:
TPS AU works fast! AU on FRANCE 4 [or any channel on that transponder]. Works great, no problems with flickering and freezing!
D+, too!
Premiere also!
Showtime and Pehla tested by anyone? The reports are that, at the moment, they are not working AU...
Enjoy [you lazy sods, who can't be bothered to read a bit, too...]!!:thum::clapping: