Search results

when the problem started last year, I mentioned it to my card supplier. He said that the newer satellite receivers aren’t capable of doing what the tm7100 does. He also said that avoid any Linux machines as they aren’t compatible with the viaccess cam. he said avoid the 8000 combo as it never...

It’s TM5402 M3. Using 1.46p. Had to fiddle around with the software on this as I was having issues with my canal digitaal card. I have 2 cams (cards BIS Tv & Canal Digitaal). I have both the cams in the tm7100 and using smart wi share the canal digital to my tm5402, using cam and smart wi card...

It’s BIS TV (France) card. Won’t work in the multicrypt card slot, won’t work in a normal viaccess cam either. It’s called ”secure crypt” and it has a padlock in the cam. I also use Smart WI as I have a Canal Digitaal card. I have a Linux receiver which it doesn’t work in, but that does work in...

thanks, I don’t know anyone that I could trust to do that

It’s viaccess secure cam. It won’t work in my tm5402. Some security thing apparently.

It’s not Freeview HD, but I use it for the satellite channels only. I’ve been told that Linux based machines won’t work with the cam I have (secure cam). And have been advised against the 8000 as it has various issues. So it would be “easier” if I could get the TM7100 to work

With the circuit board saying 8000HDV, I was wondering if that meant it was the same board used in both receivers and although the software/firmware would be different the physical parts (eg tuner) would be the same. If this was the case I would buy the 8000 that Technomate still sell and take...

everything physically on the circuit board is fine, or at least seems to be. tuner one works for about 1/2 hour, then “no or bad signal” is displayed on screen. If I put an external fan (house fan) blowing on the casing, “no or bad signal doesn’t appear” and it works ok. after replacing the fan...

Hi i have a TM7100 HD receiver. I’ve been battling with this off and on since last year. Replaced the fan as it had become noisy, replaced the hard drive as that had seized up. But tuner one only works in the cold weather or if I have an external fan blowing on it constantly. Tuner 2 is ok...

Hi Hustler (19deg East Astra) has a bar scrolling across saying frequency changed to 12722 H 22000. When I put this into my HD satellite receiver (Technomate TM7100) it's showing no signal? If I change polarity to Vertical then it is showing signal strength but only loads channels called FR3 &...

Hi, I have a Canal Digitaal Netherlands card. I want to change the maturity rating (I have done this on a previous card but can't remember how I did it). It's asking for a PIN, I've tried 0000, 1234 but it says the pin is wrong so won't change the maturity rating. Does anyone know what the Pin...

Hi there, I currentlt have a dual feed fixed dish 13/19deg east with a Technomate 1500 Ci, and also have Humax 5400CZ with a motorised dish 28deg E to 30 deg West, I have a Dragon Cam and Diablo Cam ver 2.3.