OpenPli 8.3 - OK
Both with ncam 13.7 and Oscam Icam by Kitte888 runing smoothly
On path menu-setup-system-customize You have to set 3 values to work properly
- Include ECM in http stream - NO
- Descramble sending http streams - YES
- Descramble receiving http streams - NO
And in oscam.conf You can put this
[streamrelay]
stream_relay_enabled = 1
stream_emm_enabled = 5
stream_relay_ctab = 098D,09CD
Cobraliberosat dont have installed , so no testing
OK, i have Octagon SF8008 , but both Octagon and Qviart run under same processor , there should't be any major differences
Both with ncam 13.7 and Oscam Icam by Kitte888 runing smoothly
On path menu-setup-system-customize You have to set 3 values to work properly
- Include ECM in http stream - NO
- Descramble sending http streams - YES
- Descramble receiving http streams - NO
And in oscam.conf You can put this
[streamrelay]
stream_relay_enabled = 1
stream_emm_enabled = 5
stream_relay_ctab = 098D,09CD
Cobraliberosat dont have installed , so no testing
OK, i have Octagon SF8008 , but both Octagon and Qviart run under same processor , there should't be any major differences