There are a some people having problems getting the Auto Rolling feature working. (I being one of them).
If you have ECM Keys working, but don't have auto roll with the EMM keys working, then this is where to be.
The format within the SoftCam.key
AU keys:
P <srvid> <UA> <key>
example:
P 1234 12345678 11223344556677
I have used this format, but the logging shows no hint of acknowledging these entries, and shows the same as if i removed these lines. Now, if i put in the ECM keys, the logs shows it, and decrypt's the channels.
So, please, if you suspect what is going on, I (we) could use your help to get the auto rolling feature working as I have been told by others on here, it does work.
Thank you.
If you have ECM Keys working, but don't have auto roll with the EMM keys working, then this is where to be.
The format within the SoftCam.key
AU keys:
P <srvid> <UA> <key>
example:
P 1234 12345678 11223344556677
I have used this format, but the logging shows no hint of acknowledging these entries, and shows the same as if i removed these lines. Now, if i put in the ECM keys, the logs shows it, and decrypt's the channels.
So, please, if you suspect what is going on, I (we) could use your help to get the auto rolling feature working as I have been told by others on here, it does work.
Thank you.