hi,
problem 1: error"no ca found"
....Anyway you have flashed with a unpatched image !!!
problem 2: i'm can't flashing new image:
use always DreamUp with a null cable, NOT over Network
You must try it again it will run, if fault comes again try it once again and use of course wright image.
(i use Flashwizard 6.3)
sometimes it needs more tries (4-5), you have wright image?
Use 9pin to 9pin female to female null modem cable.
Run DreamUp on Com1 or Com2. Click connect in dreamup. Plug the power cable into the box. Then choose flash and choose the img file you want to load.
10min and your done.
I don't use flash erase, but sometimes its better to use.
Use Image File (.img) or a (.nfi) file
Instructions:
Disconnect all cables from your dreambox, including the power
Connect the null modem cable to the dreambox and to your PC
Load Dreamup.exe
Click Connect
Connect the power and the bootloader should be copied to the box
The message should now say 'Box attached and Ready'
Click Flash on the right hand side and select the image to be flashed
Click Yes or Ya (depending on the version)
Note: If you're flashing a backup image, select NO.
The image should then be uploaded to the box
There will be a countdown timer at the bottom of the program
After the image is uploaded, it will be flashed to memory
Click OK and close down Dreamup
Power off the dreambox for 30 seconds then power up
If any errors appear, check all cables are connected properly and repeat the process but do not use the PC while it's running
I do not know why, but after using old version dreamup,now all ok
here is an old one try this Dream-UP 1.3.2.1
click