Added feature to webif for viewing/downloading log files (console logs & n2stream).
Added some working stuff to the "stream" section of the webif, it isn't done yet.
Added MAP 3B interrupted (from 09/29/2008 ECM)
Fix for freezing on DISH/BEV due to map rotation.
Attached: Binaries, Sources, e1 & e2 Gemini tarballs.
15/10/2008
[B]v0.92[/B]
- Added an extra command-line parameter to the n2stream
processing option to show the execution summary only.
- Some changes to the st19 simulator:
- Implemented emulation of ROM102 hardware timer interrupts.
- Rewrote memory segment management, it's now clearer (albeit slower).
- General clean-up for consistency with rqcamd programming standard.
- Some changes in preparation for the WIN32 version.
- Fix for crashing/blackout on some BEV channels due to CaID changes.
[B]rqcamd 0.95 [/B]
07.11.2008
- Fix for emu stalling on BEV channels with no N2. It should now
resume normally when switching back to a N2 channel.
- Added validation and warning so only one instance of rqcamd
can be running.
- The "configuration" and "stream information" sections of the
webif are complete. So the rqcamd webif is now officially *done*.
New options will be added in the future.
NOTE 1: There were some changes made to the .conf file, it is
recommended to use the rqcamd.conf file that is included in this
release to avoid possible problems.
NOTE 2: I am aware of a problem where rqcamd stops working randomly
after a few hours. i have already taken a look at this and it appears to
be a map interrupt in rotation that is causing the problem very sporadically,
it'll be solved in a future release.
[B]rqcamd 0.96[/B]
08.11.2008
- Some changes to provider identification made in v0.95 broke
support for DGS and Triple Dragon. This is fixed now.
NOTE: As of this release, i could not test it on a Triple Dragon.
Please report back with logs if it isn't working.
11/11/2008 v0.97
- Yet another fix due to provider identification issues, this time on the Triple Dragon. ** All boxes should be working ok now **
- Fix for current DISH MECM.
Attached are binaries, Gemini1 & Gemini2 keyless tarballs.Fixed a bug when saving configuration changes on the webif: Now, if rqcamd is connected to a cardserver, it is disconnected so it auto re-connects and new connection settings take effect.
Some tweaks to the MAP code.
Fix for current DISH MECM.
1:14/12/2008 v1.02
2: - Fix for current DISH MECM.
3:
4:
[CaID:1816]
ecm_table=80
priority=1
[CaID:1816]
ecm_table=80
priority=9
This change in the config file is not necessary for ROM240 CS.
Attached are binaries, Gemini1 & Gemini2 key-less tarballs.
@cepheus, please confirm adding to PB, Merry X-Mas & Happy New Year.