Sky Italia & Tring in oscam/cccam

[rigsby]

Hi there, i am quite new to this forum but i hope somebody can help.

I am looking for a suitable config for two cards different cards to be read at the same time.

I have Tring plus card already working in Oscam/CCcam 2.1.3
& i am looking to ADD in a Sky Italia (09cd) card into the same server.

The box is a DM800se so it has two card slots.

I have used the Sky Italia card in CCcam 2.2.1 & it works quite well & it is not hot at all but Tring wont work in CCcam so it has to be Oscam/CCcam for this project.

I have a boxkey ok, so it's just a matter of getting a config that will read & share out both cards on the same server in the same box, at the same time.

If anyone has any advice or config, that would be most appreciated.

Regards
rigsby

 

[xxxAxxx]

in oscam.server (which you all ready have sky card) create other reader

[reader]
label = anything what u like
Protocol = internal
detect = CD
device = /dev/sci0 or 1
Group = 2
EMMCache = 1,3,2
PinCode = 1234
caid = 0baa
ident = 0baa:000000


then in oscam.conf just open port for newcamd....you will be fine....

and read wiki in oscam forum every thing you need to know is there

 

[Brummie]

and dont just use CCCam to open your italia card or it will burn it out,it will open it ok but end up burning it out.

 

[rigsby]

in oscam.server (which you all ready have sky card) create other reader

[reader]
label = anything what u like
Protocol = internal
detect = CD
device = /dev/sci0 or 1
Group = 2
EMMCache = 1,3,2
PinCode = 1234
caid = 0baa
ident = 0baa:000000


then in oscam.conf just open port for newcamd....you will be fine....

and read wiki in oscam forum every thing you need to know is there

Hi there, thanks for your reply.

I have the Tring config working already, it is the Sky Italia that i need to add another reader for & i was just wondering what the best config is to ADD in the Sky Italia config.

Cheers