With last Oscam Emu version (776 - revision 11438) SIS (4.8e) stop auto update Key´s...
Is it happening to anyone else?
Should i change some settings?
Thanks!!
Try the suggestions here (in blue) - worked for me.
With last Oscam Emu version (776 - revision 11438) SIS (4.8e) stop auto update Key´s...
Is it happening to anyone else?
Should i change some settings?
Thanks!!
Try the suggestions here (in blue) - worked for me.
did you read this
https://github.com/oscam-emu/oscam-patched/wiki/PowerVU-config#november-2018-update---attention
not saying that what your using as reader is wrong
as we dont know
but read it
It could be some change on Power Vu used by Sis?
Thanks for your answer...
I already use those settings!!
Until today I was using previous version (OSCam-Emu version 775 - revision 11438). Everything was working ok with auto update (Afn and Sis).
After i change to version 776 Afn continued to work fine with auto update but Sis stopped...
It could be some change on Power Vu used by Sis?
Like you were said in the other forum, you need the disablecrccws_only_for = 0E00:000000 in ALL your powervu readers, so they work properly.
Probably because @34.5°W other srvid parameters and for this satellite need to create a separate group of keys in the SoftCam.Key.How should I write AFN EMM keys in softcam.key file for 9.0 E and for 34,5 W?
When I write them with P 0009 ident then they're OK at 9.0 E but not OK at 34,5 W.
Probably because @34.5°W other srvid parameters and for this satellite need to create a separate group of keys in the SoftCam.Key.
You need to see what srvid the AFN channels on this satellite, and in accordance with this to create a new group keys for these channels with separate identification.I've tried with other ID too (P 0345) but not OK.
Is it possible to watch MTN package on 4132 R 30000 frequency?
For the MTN package, there is no image for this moment. The keys are downloaded but no image.Is it possible to watch MTN package on 4132 R 30000 frequency?
How should I write AFN EMM keys in softcam.key file for 9.0 E and for 34,5 W?
When I write them with P 0009 ident then they're OK at 9.0 E but not OK at 34,5 W.
Like you were said in the other forum, you need the disablecrccws_only_for = 0E00:000000 in ALL your powervu readers, so they work properly.
Try the suggestions here (in blue) - worked for me.
No.
I changed to the same Oscam-Emu version, and AU is working fine (after updating settings) on the PV providers I tested, including SIS.
If you are sure it isn't a settings issue, try cleaning your keyfile of old keys. Worth a try.
Like you were said in the other forum, you need the disablecrccws_only_for = 0E00:000000 in ALL your powervu readers, so they work properly.
Try the suggestions here (in blue) - worked for me.
No.
I changed to the same Oscam-Emu version, and AU is working fine (after updating settings) on the PV providers I tested, including SIS.
If you are sure it isn't a settings issue, try cleaning your keyfile of old keys. Worth a try.