You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
new VTI image vti_8-0-0 ?
- Thread starter qwesta
- Start date
Jimdefruit
Registered
- Messages
- 64
I am not having any problems with VTI 8.0 but it did seem to need a double reboot originally.
My problem is I can have my card readers to operate. I use internal reader and external smargo, both can't operate. Oscam shows: no creditentials.
Oscam configuration is correct, running smoothly under VTI 7.0.1 (but not with Nov.20th update).
I updated my VuDuo2 with new VTI from the pen (to flash memory), then restored channel list with Dreamboxedit, then oscam with configuration and not possible to watch any channel with my local cards. I need to underline - there was no plugin which could spoil my VuDuo2, just VTI8 in flash
Then oscam gives messages:
intdown [internal] creating thread for device /dev/sci1
intdown [internal] ERROR: Opening device /dev/sci1 (errno=16 Device or resource busy)
[internal] Detected seca/nagra (seca3) card
Demuxer #0 no suitable readers found that can be used for decoding!
I can't use VTI 8, at least with oscam. The only option I have is to restore VTI 7.0.1 from the backup. Dot't forget to make your own before updating with VTI 8
Oscam configuration is correct, running smoothly under VTI 7.0.1 (but not with Nov.20th update).
I updated my VuDuo2 with new VTI from the pen (to flash memory), then restored channel list with Dreamboxedit, then oscam with configuration and not possible to watch any channel with my local cards. I need to underline - there was no plugin which could spoil my VuDuo2, just VTI8 in flash
Then oscam gives messages:
intdown [internal] creating thread for device /dev/sci1
intdown [internal] ERROR: Opening device /dev/sci1 (errno=16 Device or resource busy)
[internal] Detected seca/nagra (seca3) card
Demuxer #0 no suitable readers found that can be used for decoding!
I can't use VTI 8, at least with oscam. The only option I have is to restore VTI 7.0.1 from the backup. Dot't forget to make your own before updating with VTI 8
Vu+ Duo2 not support updade in multiboot
Hi
I have BlackHole 2.13 in flash. I installed VTI 8.0 in my hard disk with Meoboot.
No problem during the installation.
VTI 8.0 started and works fine. I got a message for an update available. I install the update. My Vu+Duo2 reboot and doesn't start anymore.
I installed again VTI 8 and a same problem after installing the requested update.
Perhaps the bootloader is corrupted.
Do you have the same problem or have you any idea how to solve the boot problem ?
Sorry for my poor english
Regards
Hi
I have BlackHole 2.13 in flash. I installed VTI 8.0 in my hard disk with Meoboot.
No problem during the installation.
VTI 8.0 started and works fine. I got a message for an update available. I install the update. My Vu+Duo2 reboot and doesn't start anymore.
I installed again VTI 8 and a same problem after installing the requested update.
Perhaps the bootloader is corrupted.
Do you have the same problem or have you any idea how to solve the boot problem ?
Sorry for my poor english
Regards