Hello,
I have installed the new Gemini 4.30 and CCCam 2.07 on my box (the prevous config was Gemini 4.20 and CCCam 2.06). Until the new installation, all programs that I watch worked fine. I have a subscription card and it work with CCCam. When I install the new software, the programs that I pay work, but none else, exept the free programs. Probably I omit some important step. That is what I am doing.
1. I flash the memory of the box (from DreamUP).
2. I install the image (with DreamUP). Restart.
3. I install CCCam 2.07 from the box. Start CCCam.
4. I copy with ftp one new key in the directories /var/keys and var/scce (because of the AU of T*S).
5. I put the my satellites and bouquets (with dreamboxedit).
6. I restart the box.
After all of this - I have all working exept -
I. EPG - nowhere.
II. After 5 to 10 minutes positioned on Fr4 I have T*S, but when I jump to another bouquet, I must wait again 5 to 10 minutes.
Where I made a mistake?
I have installed the new Gemini 4.30 and CCCam 2.07 on my box (the prevous config was Gemini 4.20 and CCCam 2.06). Until the new installation, all programs that I watch worked fine. I have a subscription card and it work with CCCam. When I install the new software, the programs that I pay work, but none else, exept the free programs. Probably I omit some important step. That is what I am doing.
1. I flash the memory of the box (from DreamUP).
2. I install the image (with DreamUP). Restart.
3. I install CCCam 2.07 from the box. Start CCCam.
4. I copy with ftp one new key in the directories /var/keys and var/scce (because of the AU of T*S).
5. I put the my satellites and bouquets (with dreamboxedit).
6. I restart the box.
After all of this - I have all working exept -
I. EPG - nowhere.
II. After 5 to 10 minutes positioned on Fr4 I have T*S, but when I jump to another bouquet, I must wait again 5 to 10 minutes.
Where I made a mistake?