Need help with sharing membership with edge nemesis

[mgharbawy]

Dear Ferret and dear brothers
After I installed the new imadge Edg-Nemesis 2.1 in to my clone DM800, I download the Cccam emu and the Config for it and I put the Cccam membership file in to the ETC but it didn't work " it works with Gemini imadge and it works with my other dream500 so what is wrong now with this imadge why is the sharing doesn't work with it or do I have to do something else.
Please need your help and your reply ASAP.
Thanks
Magdy

 

[Brummie]

did you select CCcam and press ok, press the blue button then use > button select CCcam and press ok, you will see starting CCcam on the screen.

 

[mgharbawy]

Hi Brother
Yes sure I did that and I select the Cccam Emu and it works but the channels want work
Looking for your help
Thanks
magdy

 

[Ferret]

Maybe the config is corrupt try a new config file a just paste you lines into it reboot and check.

Also make sure the port cccam is using is open i router.

 

[mgharbawy]

Hello Ferret
Thanks for your reply,yes it seems that the config was corrupt so I tried another and it works, thank you so much
But there is another problem I am facing now one of the sat " Eutelsat W2" 16E doesn't want to work all the other sats works but not this one, I could download the channels on this sat but there is no channels works and when I try to go to any channel from this that the Dream hang up and restart again this happen every time I go to this sat, so what is the problem now
Looking always for your help and for your quick reply please.
Thanks
Magdy

 

[Brummie]

go to 13 east on a fta channel ARTE then menu/setup/service searching/positioner setup/ then press the red button change sat to 16 east manually enter the freq 10892 H 27500 3/4 then press the yellow button to search east i only get 46% on a 1 meter dish