Magic zum Matrix

Status
Not open for further replies.

elgeneral

Well Known Member
Messages
7,811
Magic zum Matrix

German Infos and soft

Translate wiht Google


How do I make a Magic Module Matrix Reloaded with the CAS 2

1. cas studio 6.8a
2. Cam Module button.
3. Click Cams Magic.
4. Matrix Reloded click.
5. Cam insert and delete everything.
6. Xilinx write "Matrix Cas"
7. Go and "MR 1180 bin download and click on Write.
And wait until finished.

How do I make a Magic Matrix Reloaded a module with the CAS 2

1. cas studio 6.8a
2. Cam Module button.
3. Click Cams Magic.
4. Magic Cam button.
5. Cam insert and delete everything.
6. Xilinx write Magic Cas "
7. Go Pentaplast and 1:11 am to load and click Write.
And wait until finished.

How do I make a Magic Matrix Reloaded a module with the CAS 2 and Penta 1:20 mbf file.
1. The program Cas Interface Studio 4.7.1 Open:
2. Click on the button "Magic Cams" and then again on "Magic Cam
3. The Cam and insert the data from the CAM to be read and displayed
4. Erase all the button press
5. After deleting the Xilinx must now file loaded werden.Drücke the Write button
and now select the file from Xilinx. In our case this means MAGIC.CAS File
after selecting the file will be loaded and transferred to the CAM.
6. Now open the file and Dreamload Flasch "TOSHIBA TC58FVT160AFT" to download and click Write.
7. The start address set to 10000.
8. At the Open File and load Pentaplast 1:20 mbf and Write.
9. If it is described in the module and plug the receiver Dreamload appears when the module rausziehen and again it should appear Pentaplast 1:20
10. Now, from the Matrix Reloaded MagicCam become one.


Your Magic Module since the last update only as "invalid CI module" of your receiver detected and it can not be programmed?

Here is the solution!

Their brews the Cas Interface 2 (USB connection) and the program "Cas Interface Studio 4.7.1.
Next we need the files
"Matrix.cas + zBmr1170.bin" for programming on Magic Matrix Module
or
"Magic.cas + and Penta 109.bin" Magic for normal module.

And now, go go!

Magic-module in the Cas Interface2 purely and stuck with the USB cable and PC.

Run the program "Cas Interface Studio 4.7.1" and then click on the icon "Magic".
Then we press the "Wizard" and the miracle can begin.
The first bodies we have a (Select type of Cam) Magic for Magiccam or matrix for Matrixcam (I Matrix set).
Then we load the Flash file e.g. "mr1170.bin" and the Xilinx File "Matrix.cas". Now we press on Next and then click Connect.
If the yellow-red dot on going green, it was the connection between Cam and program established.
Now we press on Next again and then to write, the program works. Now we wait until the message "Device successfully programmed" comes. Now press "ok" and the Magic Module Cas Interface2 taken and reinstecken.Receiver into the receiver on and wait until "Ci module initialization" terminated because ist.Siehe, Magic module is saved!


Thanks to Walo0_2
 
Status
Not open for further replies.
Top