low signal on W2...

[X0N1]

hello,

i have low signal on W2 sat. on the same position with my db7000 i recieved 78-80% Quality. (i have a motor dish)
can anyone help me to configure lnb, diseqc, etc., parameters on this sat config page. i'm affraid i cannt see hd channels because of low signal.

p.s. actually hd picture shows up but is heavily 'damaged' (like a very bad jpg picture). there is something strange: i/4 or 1/5 of the upper frame shows correctly but refreshes very slowly.


thanks.

 

[OldSkul]

on azbox signal on w2 should be above 38%. Some transponders are very weak. You will probably have to check your sat-dish

 

[X0N1]

on azbox signal on w2 should be above 38%. Some transponders are very weak. You will probably have to check your sat-dish

DREAMBOX shows over 70% on the same position... i think it's a AzboX "issue".... or W2's configuration is not set correct by me.

anyway, thanks!

 

[OldSkul]

different receivers have different signal quality percents.
I too have dreambox and it shows some wierd numbers...

Check if this transponder has 45+ signal on w2: 11095 H
This transponder is weak one.

 

[X0N1]

different receivers have different signal quality percents.
I too have dreambox and it shows some wierd numbers...

Check if this transponder has 45+ signal on w2: 11095 H
This transponder is weak one.

it gives me 47-48 %... while the HD channels are on 10975.92 H, gives me 46%.

do you think that this (46%) signal quality is giving me problems on HD channels? Do HD channels need more strong signal in order to display correctly comparing with SD channels?
if it is not a problem for you, can you please help me by listing here the satellite configuration parameters? (i have a motor dish)

ThankYou again, OldSkul!