How do I enter biss keys?

[The plant man]

Hi, I need to quickly enter Biss keys on my TMF3/5 for thr Arsenal v Bournemouth match. Ive just got the transponder ok but havnt had the box long and dont know how to do it. Any help greatly apprecs

 

[william-1]

Dial 8280 with your remote then enter the keys on any line,

Your receiver must be patched for this to work.

http://www.sat-universe.com/showthread.php?t=263578&page=2

 

[harshy]

I need to figure it out how to enter keys to make it work in Oscam at the moment I have to switch to cccam

 

[PAPASCAR]

Hi
Is this patch also good for vusolo2?
Or what would you suggest to recieve biss channels
Thank you

 

[barney115]

I need to figure it out how to enter keys to make it work in Oscam at the moment I have to switch to cccam

Better if you try tell us what Box your using ??

i will guess you have Enigma2 box ??
if so have you got Oscam running yet or not ??
on Linux E2 boxes it will be same as CCcam only you need oscam.key file instead and have correct path in your oscam.serv file so when you start oscam that your oscam.key file will get recognised .
i suggest read some tutorials in oscam section/s which may help your cause greatly i think : )
Good Luck :thum:

Hi
Is this patch also good for vusolo2?
Or what would you suggest to recieve biss channels
Thank you

Same as above but patch on link in above post is only for TM5402 reciever NOT VU Solo ..
i suggest you open new thread in VU+ Solo chat section instead of hijacking this thread with off topic questions .
Good luck aldo :thum:

 

[LoginX]

For VU+ Solo2 use CCcam 2.1.3 with constant.cw

 

[kebien]

oscam works for biss in my setup
Key layout
F TTTT1FFF 00 KKKKKKKKKKKKKKKK
Where
KKKK.....=key
1FFF = ecm pid,some providers is different than 1ffff.
TTTT= channel sid