Help for NB501

[pmos_hafi]

Dear Masters

I have uploaded the 21T8 firmware from www.myneotionbox.com into my NB501 and now it doesn't work .The panel remains dark and I have a bad half dark screen with only one sentence "Please wait" . I have tried to upload the 21T7 again but the same problem remains . Would you please help me in this regard ?

Thanks

 

[d.j.carusso]

Try firmware from here that is tested and works good.
http://www.sat-universe.com/showpost.php?p=107859&postcount=4

 

[pmos_hafi]

Dear Master

Thanks a lot . It has been repaired .Now the remaining problem is that I can not enter to the coding area (Receiver information--->2580 doesn't work) and I can not see any code to change it manually .

Would you please help me in this regard ?

 

[isenguard]

u better use 21t7 firmware. better and more stable than 21t8

 

[mgalic2]

Dear Master

Thanks a lot . It has been repaired .Now the remaining problem is that I can not enter to the coding area (Receiver information--->2580 doesn't work) and I can not see any code to change it manually .

Would you please help me in this regard ?

Put in the last RK file, and you will be able to enter in the coding area.

 

[malioli]

Hi,

Like everybody told you 21T7 is better then 21T18.
I has 21T18 five mounts ago and all time I has lot of problems, like
1. Frizzing all time
2. Losing list's, satellite...
3. Troubles with settings, and many more
After taking good advise from people in this forum I was cleaned my receiver (with mini application)and get back on old 21T17. Now everything work prefect. I has just five time frost my NB. That's it!
My suggestion to you is go back on 21T17.

Enjoy! :thum:

 

[d.j.carusso]

Dear Master

Thanks a lot . It has been repaired .Now the remaining problem is that I can not enter to the coding area (Receiver information--->2580 doesn't work) and I can not see any code to change it manually .

Would you please help me in this regard ?

Try 3384

 

[cmds87™]

Dear Master

Thanks a lot . It has been repaired .Now the remaining problem is that I can not enter to the coding area (Receiver information--->2580 doesn't work) and I can not see any code to change it manually .

Would you please help me in this regard ?

Hi,
After Firmware 21T7, send to 501

1- Emu rp_t352_nb501
2- k€y table rk_nb501

After this you can enter to k€y table with 2580 code

:thum:

Try 3384

Hi d.j.carusso
The 3384 code is not for access to k€y table, it's only for enter in the Admin Mode menu.
:thum: