[Help] Android DVB-S2 dead (bricked)

barney115

barney115

Donating Member
Staff member
Administrator
Messages
24,801
on the underside of this Andriod player there is a Reset button its very hard to see but its there for sure
you must get a pin and while Andriod player is connected to power hold reset button with a pin for upto 30secs this will basically factory reset your Andriod player
once reset then your player automatically is back to normal
i had this happen to me with a very similar Andriod device
as in your link .
i hope this will help you out and get it back working again .
Good luck : )
-
Barney
 
F

frankviana

Registered
Messages
73
barney said:
on the underside of this Andriod player there is a Reset button its very hard to see but its there for sure
you must get a pin and while Andriod player is connected to power hold reset button with a pin for upto 30secs this will basically factory reset your Andriod player
once reset then your player automatically is back to normal
i had this happen to me with a very similar Andriod device
as in your link .
i hope this will help you out and get it back working again .
Good luck : )
-
Barney
Click to expand...

I did.... but with wrong bootloader and firmware, I don't CWM again. I tried several times and pressed reset button too many many times and different recovers...

I think only jtag to write flash again... but I don't know how.

Thanks.
 
X

xxxAxxx

Super VIP
Messages
1,172
i guess your box is AmlogicM3....

did u try to upload recovery.img u-boot.bin ???? if is ok....

when u do this u have no potion on remote control... upload the frimware m3dvb in sd card and flash the box....

also on board u can reset the flash chip...i forget now what pin was its a while i go i play with this ...7-9 or 5-7 u need to shorted then power on mybe u can bypass the sd card flash process......
 
F

frankviana

Registered
Messages
73
xxxAxxx said:
i guess your box is AmlogicM3....

did u try to upload recovery.img u-boot.bin ???? if is ok....

when u do this u have no potion on remote control... upload the frimware m3dvb in sd card and flash the box....

also on board u can reset the flash chip...i forget now what pin was its a while i go i play with this ...7-9 or 5-7 u need to shorted then power on mybe u can bypass the sd card flash process......
Click to expand...

Yes, Amlogic M3. I used this informations to recovery using SD card: "Copy aml_autoscript, uImage_recovery (renamed recovery.img), fw of you choice on FAT partition of prepared sdcard plug in box while holding reset button"

My receiver has reset button and I don't know if is the same pins on motherboard.

I used different u-boot.bin and recovery (sdcardmaker, HDDRawCopy1.02Portable) with some images too.

Used this informations too:

"amlogic boxes can boot recovery image from sd.

on most boxes you have to prepare sd with SDcardmaker and your box related (or near related) uboot.bin put on the by SDcardmaker created FAT32 patition: recovery.img (or rename uImage_recovery ) and update.zip, boot with reset pressed."

no sucess too..

Thanks
 
You must log in or register to reply here.
Top