good signal but no picture on vu+uno

[mo.p]

ive got my friends vu+uno box showing good signal but no picture
ive config tuner
set up as
config mode = simple
mode = single
satellite = satname ie 28.2e
send DiSCEqC = no

when i do service scan it gos like scan in progress- 100%done 0 service fond! so then i put Catseye E2 Settings File when i go to channels showing good signal but no picture
but can not seem to decode them. Error on screen is "no data on transponder timeout reading pat" he has tried to re-flash the bux but still the same problem any help/info would be greatly appreciate

 

[Ferret]

Is the dish pointed at the correct sat ?

 

[mo.p]

yes dish pointed at the correct sat bcoz my box work fine

 

[Ferret]

Faulty tuners would behave like this returning no channels

Take the box to your dish setup and try it there.

 

[mo.p]

yes m8 i tryed that but no luck but ive got Vu+ Ultimo with three tuners i am useing two of them can i use 3rd tuner to this vu+uno????

 

[mo.p]

hi guys if is Faulty tuner can motar work?? help/info would be greatly appreciate
Reply With Quote

 

[Ferret]

yes m8 i tryed that but no luck but ive got Vu+ Ultimo with three tuners i am useing two of them can i use 3rd tuner to this vu+uno????

You can use that tuner yes worth a try to pinpoint whats wrong.

 

[mo.p]

ok ive tryed the new tuner but samething good signal but no picture so its nothing wrong with tuner bcoz same tuner work fine in VU+ Ultimo i dont what to do help/info would be greatly appreciate

 

[ellblud]

Try upgrading the FPGA and the satellites.xml

 

[mo.p]

thanks m8 but it was my mate box he sold it as spares or repairs on ebay now but thanks what is the FPGA ???????

 

[RIDER]

[PDF]Vu+ Manual FPGA Upgrade - VuPlus