Dreambox800HD
- Thread starter thanzeem
- Start date
i have flashed mine with this image its very stable and has tspanel etc already installed in it http://www.sat-universe.com/showpost.php?p=783370&postcount=13
hi m8 i tryed this image i reley liket it but hd channels dont work is your hd channels working ok plz let me know if they are
thank u m8 i will try again
That Dreambox loader#76.... flash with this loader#82 image after show any CA Error or something????
if you have ERROR NO CA on led follow below
insert null modem cable and ethernet cable, open dreamup and click on connect, at this point now insert the power cable.
now on the led screen you should see serial mode and an ip.
put that ip into your url and flash this bootloader below,the way you normally flash an image it only takes seconds, are you sure you have a sim 2.01 76d, thats what mine is and mine is ok with that image.
sim 2.01 76D can goto 82 as long as the image is for sim 2.01
insert null modem cable and ethernet cable, open dreamup and click on connect, at this point now insert the power cable.
now on the led screen you should see serial mode and an ip.
put that ip into your url and flash this bootloader below,the way you normally flash an image it only takes seconds, are you sure you have a sim 2.01 76d, thats what mine is and mine is ok with that image.
sim 2.01 76D can goto 82 as long as the image is for sim 2.01
use the enforcer from this post, i use the one in different method folder open dreamup and enforcer press connect and follow post above, if you see the ip in serial mode use your url not dreamup to flash it.
http://www.sat-universe.com/showthread.php?t=141826
http://www.sat-universe.com/showthread.php?t=141826
hello,
you need to flash your DM By DreamUp, with an old image like this one "sim201e-76A-gemini2-510-dm800-20100721145005.nfi"
then re-flash it with 76D
I had the same problem, now it's OK!!
NB: If you have HDD inside you can disconnect it, may be it's better
Good Luck
you need to flash your DM By DreamUp, with an old image like this one "sim201e-76A-gemini2-510-dm800-20100721145005.nfi"
then re-flash it with 76D
I had the same problem, now it's OK!!
NB: If you have HDD inside you can disconnect it, may be it's better
Good Luck
- Messages
- 17,545
Menu-setup-system-Language
- Messages
- 6,086
not need setting language, but channels where change audio language.
- Messages
- 17,545
All you can do is press the audio button on each channel and change to your Language, this is not Engima1 you can not set it on the web-interface.
I think only image that will allow you to setup a Audio Language default is PLI all other image you need to change each channel manually
- Messages
- 17,545
Press button underneath Enigma 2 " Satellite Receiver " that is E1