hallo! i have a Digiquest S111 CI.
the chrismtas day i was uploading the firware with new channels, when the power gone out !!
i can send firmware, channels, .... but when i turn it on it shows 'e004' and then nothing: no display, no signal: nothing
i've tried send both the concorde FW and the vantage FW...it receive data, but after the reboot it shows e004.
in internet there is nothing about this error code, so i don't know what else to do.
i've tried also to disconnect the display connector on the motherboard and send the fw, but nothing
any ideas?
thanks for your support
the chrismtas day i was uploading the firware with new channels, when the power gone out !!
i can send firmware, channels, .... but when i turn it on it shows 'e004' and then nothing: no display, no signal: nothing
i've tried send both the concorde FW and the vantage FW...it receive data, but after the reboot it shows e004.
in internet there is nothing about this error code, so i don't know what else to do.
i've tried also to disconnect the display connector on the motherboard and send the fw, but nothing
any ideas?
thanks for your support