Hi there, can anyone tell me if latest software from 28th December working or not.
I cannot get in to run.
after loading softeware and entering MENU 9998 nothing happens - when I watch the T2 signal strength it continually goes to 0 % and when I change transponer it shows again for a few secods then goes back to 0 % - I know W3 signal is ok as I have more than one dish on W# feeding Y^ dongles etc for other people.
If I disconnect the T1 LNB input the T2 signal comes back again without cutting.
Can someone help with above - perhaps the DC 200 faulty or I am doing something silly - and also what is the correct frequency fot the DC2000?
Thanks
I cannot get in to run.
after loading softeware and entering MENU 9998 nothing happens - when I watch the T2 signal strength it continually goes to 0 % and when I change transponer it shows again for a few secods then goes back to 0 % - I know W3 signal is ok as I have more than one dish on W# feeding Y^ dongles etc for other people.
If I disconnect the T1 LNB input the T2 signal comes back again without cutting.
Can someone help with above - perhaps the DC 200 faulty or I am doing something silly - and also what is the correct frequency fot the DC2000?
Thanks