configure lines to mgcamd

zod013 · Feb 18, 2013

Hello

How to configure lines to mgcamd client in Ariva 102E

manic01 · Feb 18, 2013

Need to read a little in the forum.

zod013 · Feb 18, 2013

Excuse me, I'm new here, I have not found?

JAKITAKI · Feb 18, 2013

zod013 said:
Excuse me, I'm new here, I have not found?

create a file allshares.dat

G: ip port user password deskey

Menu => Tools => update via USB => upgrade => config flash
=> File from the update: allshares.dat
=> Start

zod013 · Feb 21, 2013

Hello
I entered the file allshares.dat line "G: ip port Deskey Password" or "CWS: ip port Deskey Password" is no mgcamd written in the receiver? how to write in allshares.dat

JAKITAKI · Feb 21, 2013

zod013 said:
Hello
I entered the file allshares.dat line "G: ip port Deskey Password" or "CWS: ip port Deskey Password" is no mgcamd written in the receiver? how to write in allshares.dat

complete data, and upload as flash.cfg

zod013 · Feb 25, 2013

Hello
It does not work with USB? manually it works! can you make a backup to avoid having to enter a still manually

JAKITAKI · Feb 25, 2013

zod013 said:
Hello
It does not work with USB? manually it works! can you make a backup to avoid having to enter a still manually

must act, you must remember, the spaces between entries

and upload the receiver

menu > tools > Update with USB > flash confg > start

zod013 · Feb 26, 2013

Hello
No AC does not work with USB?

samkooke · Feb 26, 2013

hello is the new patch you can put mgcamd internet:thum:

zod013 · Feb 26, 2013

I currently 1.21B6 patch

JAKITAKI · Feb 26, 2013

zod013 said:
I currently 1.21B6 patch

new 1.22B5_patch

http://www.sat-universe.com/showpost.php?p=1012311&postcount=47

zod013 · Feb 28, 2013

Hello
I may be found error 'key' are spaced (01 02 03 04 etc ...) or (01020304 etc ...)

zozi · May 16, 2013

Hi all,
I have a same issue with mgcamd and Ariva 202E. I got the C line that I should configure with the MGCamD Client and I used web interface to enter ip port user_name pass and when I push Login button it says Login Fail. Another C line is configured in CCCam and it works fine.
Then I tried to write following in allshares.dat file and did USB update but I got same issue.
C: ip 11238 user password (C-line for CCCAM works fine)
G: ip 18000 user password 01020304...(C-line for mgcamd does't work)

Any idea how to configure C-line in mgcamd for Ariva 202e? Did I miss something?
On DreamBox for mgcamd there is file cccamd.list with following data:
CWS_KEEPALIVE = 300
CWS_INCOMING_PORT = 12000
Where I should write these data Ariva? Is it needed?
I'm using A202E_1.23B2_patch firmware.

BigSmall · Dec 18, 2013

Its not
G:
but
N:

configure lines to mgcamd

Senior Member