BBCi

[bigfoot007]

Just upgraded to the 9000, looks good to now, but now I have a problem.
I am trying to scan in the BBCi channels on 28.2. I can see that there is a signal, but when it scans it picks up no channels. I have read that the DM see`s the signal as data and you have to use the editor to change it to TV.
Has anyone got a solution to this?
I have tried importing the data as SatCodx format and still nothing.
I am using the official r7043 image.

 

[mirg]

Even you NOT have a motor dish try to scan with USAL!That sometimes work.Have you checked the Parameters for the channel you like to scan? Go to: Service Search / TP and Cannel Edit,find your satellit and than the transponder, check the data, and if nessesary edit the parameters.Skål

 

[bigfoot007]

Checked the parameters, they are all OK. Even entered the VID, PCR etc and still no luck

I have a motor but that is on the other dish, the fixed dish is on 28.2 via a two way switch. I will try with USAL.

 

[mirg]

You don't have to have installed a motor to try USAL.Just make sure that there is a good reception (both L and Q) than go to scan, and manuel put the transponder parameters in the right place!

 

[bigfoot007]

Still no go, will look at this later