Amiko mini combo problem

[toni666]

Dear friends, i have a problem, after i tried to upgrade the software on my amiko mini. i used a rs232, everything went good, then it only shows a green led light and nothing..what can i do to get my amiko back??

 

[carlos99]

when flashing with RS232 make sure you use 'all chunk' option to upload and try the latest official firmware

 

[toni666]

it doesnt work

when flashing with RS232 make sure you use 'all chunk' option to upload and try the latest official firmware

i tried that way, but there is no response from the stb..it doesn't get connected at all. is there any jtag procedure?? anyway thanks for the information

 

[toni666]

Target not connect or target is error status!
what can I do??

 

[carlos99]

are you using a usb-to-serial adapter? If so they can be very particular about which ones they will work with.

The other thing is if you've corrupted the bootloader then you won't be able to recover via RS232- you would need to jtag it, which I know nothing about with these boxes.

My advice would be to return it from where you bought it- most Amiko stuff comes with a 2 year warranty.

 

[valdek]

RS232-Toolbox for Amiko 3612--By Dekolte-and https://dl.dropboxusercontent.com/u/94231410/LAVATRONICS-282E-ALLSD+FTAHD-011014-COMBO with 1.0.7 Bootloader.abs in 0 seconds. Kaikki OK.

 

[enicdep]

Target not connect or target is error status!
what can I do??

Hi toni66,

I'm having exactly the same issue with my Amiko Mini Combo

Did you solve at the end ?

thx a lot in advance

enicdep

 

[bledibajern]

hello!
can you help me
I try flashing amiko mini combo with rs232
1. dump flash (it's ok)
2. test serial ports status (Finished)
3.collect STB information (Finished)
4.Start downloading 100%
5.Start burning.Do Not Power off 100%

but when all finished amiko mini combo again not boot (on,ON)

How can I do?
can anyone help me?

 

[snotzer]

I have the exact same issue.....loaded new abs file from amikoreceiver.com via RS232....wnet through all the motions and in the end "failed data transfer"....now box stuck in boot

 

[sdodo]

I have the exact same issue.....loaded new abs file from amikoreceiver.com via RS232....wnet through all the motions and in the end "failed data transfer"....now box stuck in boot

can you insert the usb key inside?...install software via usb...option allSW+bootloader