Zee tv ( irdeto 2) key in old Echolink ?

[highsignal]

New Zee tv ( irdeto 2) key how can i use this key on my old Echolink El 700 FTA

 

[zaforija]

switch on channel then go to tools then on key edit press ok then below select cw by pressing volume up then put you cw key from remote press ok for save

 

[empb]

switch on channel then go to tools then on key edit press ok then below select cw by pressing volume up then put you cw key from remote press ok for save

@zaforija. cw = control word. Zee TV is currently open with actual Irdeto2 keysnot a Fixed or Constant Control Word, ie more than one key to enter.

@highsignal. hope some one can help you, can you not simply use fausto via either serial connection direct to ecolink (rs232 etc)? or fausto/season interface and a cam in ecolink's ci slot (take it there is a CI Slot)?

 

[testi]

think there is firmware with i2 support for that ali-b receiver ... but you have to unpack and decrypt maincode , after that you have to put ecm and iv key in the maincode with some hexeditor ...

if you point me to the firmware you are currently using, i will try to edit it for you ..

but you have to try it as i only have some c-series receivers lying around here

 

[testi]

this is modified b-chip-firmware , don`t know if this matches your receiver, so try at your own risk and report!I`m not responsible if your receiver is dead afterwards

- seed and iv keys inserted for c+@l and ze@tv
- you have to insert the opkeys either by remote or caseditor

 

[highsignal]

My Ecolink is irdeto2 enabled already .But there is no key id for Zee Tv i used to watch Showtime and some other irdeto channels before. this is just for your info guys.

 

[testi]

ecm seed and iv key has to be in the maincode , so ou will be out of luck with your current firmware.

So you can either try the above file , or you wait for another guy trying my attached file

 

[testi]

receiver ? firmware ? more information, perhaps other guys can answer your question