ed.jenkinson
Registered
- Messages
- 1
hi everyone
i recently pulled an old wolsey satmeter 3 off the shelve in my workshop and am trying to get it up and running again, it works on vertical channels but not horizontal, i worked ok when it was mothballed a few years back, do i need to update the firmware? if so where could i get updated firm ware from
or should i just give up and not bother??
i recently pulled an old wolsey satmeter 3 off the shelve in my workshop and am trying to get it up and running again, it works on vertical channels but not horizontal, i worked ok when it was mothballed a few years back, do i need to update the firmware? if so where could i get updated firm ware from
or should i just give up and not bother??