VTI image help

[unknown]

Just switched from DE and impressed so far with this image. Just 1 problem.

The sat postioner doesn't seem to store my fine tune adjustments and just goes back to were it was. Using USALS which has picked nearly all satellites but 26e and 40e need adjustments which I cant seem to store, I had the same issues with VIX.

However DreamElite allowed to make corrections with sat positioner. Any ideas?

 

[Ferret]

Hi mate

What you need to do on tuner setup is select the advance mode.

Now you have 2 options here

But first you need to turn on the LNB for all sat positions use LNB A and store them with use usuals for this sat and enter your coordinate also select disecq 1.2 for each one.

See if that helps you store your tweaks if not you will have to turn of usuals on every sat position and manually search and then store to a position number each sat position.

Ferret

 

[unknown]

Am bit confused here mate with this :

"ut first you need to turn on the LNB for all sat positions use LNB A and store them with use usuals for this sat and enter your coordinate also select disecq 1.2 for each one."

Could show me a sreenshot of what you mean. Does mean store each sat under lnb1 lnb2 and so on?

 

[Ferret]

Menu-setup-service searching-Tuner config select tuner A

Top option Configuration mode change that to advanced then proceed as i described.No all sats will still be stored at LNB A. All this does is allow you to fine tweak position but be warned its tricky.


Ferret

 

[unknown]

Hi mate thx for help but it didnt help, the tuning would go back to the old position...am gona give up on this maybe try to multiboot dreamelite instead.

 

[Ferret]

It works that way mate as all positions are located manually so it has to store the position at what you set it to.

I use it this way.

Ferret

 

[talon_s]

I had the same problem:
Had to store each position in the tuner A config
then go to the positioner setup and manually search for the satellites.
i.e. tuner a had 19.2 stored as position 2 with ucals=no, then in positioner setup move west until it found 19.2 and store that position as 2.
Had to do that for all the satellites.

 

[unknown]

So I should store all sats under the same postion?

Never mind finally think I figured it out!