Sif image r11426 for Ipbox 9000HD

dorosk

Senior Member
Messages
100
I have installed this twice but it is getting stack on booting.

Was any body successful on this?
 

thecaretaker

Registered
Messages
41
I have the same problem. I've tried twice. My network is set up as usual, so it should work.

I was looking forward to seeing the new menu layout. :mecry:
 

dorosk

Senior Member
Messages
100
I guess you have the DHCP bug again, without a working Network it won't boot

I have tried it with and without network.

I also confirm that DGS is OK. When you install this then you have to re-enter the multi-boot commands
 

catseye

Senior Member
Messages
394
Hold 3 on your remote to boot from flash image & 2 to boot from USB stick with HDD support
 
Messages
700
cant get this to load also...
here is consol log outpput

U-Boot 1.3.1 (Oct 24 2008 - 18:09:07) - stm23-2008-03-19
Board: cuberevo (0x2D42C041)
Board: 12 dotmatrix vfd front
DRAM: 128 MB
Flash: 32 MB
In: serial
Out: serial
Err: serial
Reserve 0x2010000 bytes from 0xa5ff0000 for DGS upgrade buffer.
Setup mac address.
booting...
## Booting image at a0060000 ...
Image Name: Linux 2.6
Image Type: Blackfin Linux Kernel Image (gzip compressed)
Data Size: 1707472 Bytes = 1.6 MB
Load Address: 84401000
Entry Point: 84402000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Warning: Unable to determine if kernel is built for 29- or 32-bit mode!
Starting kernel console=ttyAS1,115200 panic=3 root=/dev/mtdblock3 bigphysarea=15 00 quiet - 0x00000000 - 0 ...
SQUASHFS error: sb_bread failed reading block 0x4f23
SQUASHFS error: unable to read uid/gid table
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,3)
 

catseye

Senior Member
Messages
394
I tried three times to get it to load & with no luck

The DGS version loads fine but doesnt have multiboot installed so cant use E2 via USB stick

Ive read elsewhere the DGS version should not have been released yet:eek:

So expect another image soon:)
 
Top