port problem

[meggymoo]

Hi all,
just wondering if you can help me out with this problem.what happens is i put an image on my azbox(tried gemini and pb),set it all up,put in my cccam cfg file and all is fine,but if i have to reboot,my card or anything else wont open.but what also happens is that it closes my port.tried rebooting and nothing happens
i then disconnect it all and reconnect my dreambox 800se(clone),and it all comes on,bearing in mind it's the same cfg file in both boxes,check the port and it's open again.
it seems as though there maybe something in the cfg file thats stopping the azbox from working after a reboot.
any help on this appreciated as it's now doing my bonce in.
cheers
meggymoo

 

[pe.tardo]

If you use a .cfg from one receiver (dm800) to another (AZ), keep in mind
that both rec's. haven't same IP, and port X in router is redirected to old IP (dm800 clone).
You can redirect again to new IP (AZ), or edit config in both
receivers and assign old IP (which has the port redirected to)
to the new receiver.

And, what FRW are you using in AZ? E2? OFW?

 

[meggymoo]

Thanks pe.tardo,
just seen this message.i changed all the details within the router to match the azbox,but didn't make any difference.
got me baffled,btw i'm using E2
Cheers
Meggymoo

 

[pe.tardo]

Did you reboot all devices (router, clone, AZ, ect)?
did you Chmod 755 to CCcam & CCcam.cfg?

CCcam.mipsel -> /usr/bin [chmod 755]
CCcam.cfg -> /etc [chmod 755]

 

[meggymoo]

Did you reboot all devices (router, clone, AZ, ect)?
did you Chmod 755 to CCcam & CCcam.cfg?

CCcam.mipsel -> /usr/bin [chmod 755]
CCcam.cfg -> /etc [chmod 755]

i disconnected the dreambox,so that was out of the equasion.
although i didn't chmod cccam.
i will try that.
thank you
meggymoo