NO CA FOUND even after successfully got this message

valentino50

valentino50

Well Known Member
Messages
907
Hi there I have a DM800se it had the ssl84d with my latest image newnigma2 I wanted to flash it with another image unfortunately I got the message after I turn it on R01:NO CA FOUND. This is what I did:
NCF repair tool sim2 v3.0 + used correct port+ used the right sim2 ssl 84d after pressing start I got this message:

Power ON DB Device [ESC to Abort]
Operation Start at: 19:30:37
DM800SE Detected !
Dreambox Detected...Ok!
Network IP Range is Not Valid
***RJ45 Crossover Cable Type Needed***
example of setting:
IP Adress: 192.168.xxxxxxx
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.xxxxxx
Sending Flash Loader...
Second Stage OK!
Boot Success & Ready For Job Process!
Authorization id: FDF148E8
Starting Repair [NO CA FOUND] Injecting Phase1...
Finalizing Job Phase2...Please Wait...
NO CA FOUND Repaired Successfully !
Operation Done at: 19:30:59

As you can see the NO CA FOUND Repaired went Successfully .
But when I put off and ON my box still show no ca found
can someone pls help
Thanks to everyone involved

Please help I am desperate ????
 
B

Bluesweeper

Registered
Messages
32
I got that message last night when i tried flashing Newnigma v4.0.9.

All I did was flash back to v4.0.8 using miniflashup button and dn800hdse box booted ok
 
Last edited:
valentino50

valentino50

Well Known Member
Messages
907
Thank you both for your answers very much appreciated.
Unfortunately both solution didn't work , but after several attempt and looking to other forums. I finally got it working..

Here is what I've done incase if that would happened to anyone.

I had to use DM Optiflasher-pro E2-v2.0.0.6 work with default network ip addrress : 192.168.1.77 cause my Modem have diffrent domaine and then from there just flashed it with Repair no ca found and inject ssl 84 et voila..
After that all I had to do is flashing the correct image through web browser:thum:
Once again thank you very much for trying to help me:clapping:
 
You must log in or register to reply here.
Top