Hi,I've just got a vu+ duo with blackhole image i have a motorised setup with a twin lnb can someone plz tell me the correct proceedure to setup the box with the motorised dish i want to connect both wires to the box, also how would i be able to record multiple channels.thanx.
Motorised setup
- Thread starter fkhan786
- Start date
- Messages
- 17,545
Hi mate
Menu-setup-service-searching-tuner config
The cable going to your motor have in tuner a and set it to
Simple
Positioner
And enter your coordinates.
You can do the same for tuner B and it will work fine or set it to equal to tuner A
Menu-setup-service-searching-tuner config
The cable going to your motor have in tuner a and set it to
Simple
Positioner
And enter your coordinates.
You can do the same for tuner B and it will work fine or set it to equal to tuner A
- Messages
- 17,545
Well it should take care of itself just record from the epg or manual timers 2 recording at the same time.
It will do it if the tuner are setup as above, obviously it will only do this from one satelite position with your dual lnb.
It will do it if the tuner are setup as above, obviously it will only do this from one satelite position with your dual lnb.
Hi Ferret,
Found and dloaded your last Backup BH 1.7.9 for motorized system.Have some Q:
-On my Vu+Duo I have now BH 1.6.6 instaled , with single LNB, connection is LAN, DHCP.Tuner A
-Satelites 42 East to 30 West.
Due to problem of impossibility to make bh Personal Backup from ver. BH 1.6.6 to ver. BH 1.7.9 (light) because of kernels incompability, I have two solutions: To configure new image again , or use ready Backup as yours.
Could you kindly anwer me can I use your Backup, or....
Found and dloaded your last Backup BH 1.7.9 for motorized system.Have some Q:
-On my Vu+Duo I have now BH 1.6.6 instaled , with single LNB, connection is LAN, DHCP.Tuner A
-Satelites 42 East to 30 West.
Due to problem of impossibility to make bh Personal Backup from ver. BH 1.6.6 to ver. BH 1.7.9 (light) because of kernels incompability, I have two solutions: To configure new image again , or use ready Backup as yours.
Could you kindly anwer me can I use your Backup, or....
Unfortunatelly only FTA channels can be cleared.Try all CAMs but no succsess.
Telnet Protokol is closed
Bootmanager: not found
Telnet disconected
Telnet login: incorrect
All this found using DCC 2.96
Network : O.K.
FTP: Connected
When try FTP on DCC2.96 left side remain empty
When check settings with Dreamset 236 receiving: Connecting to box fail.Connecting to ftp://.....The password was not allowed.
Any clue or must return to 1.6.6.
Telnet Protokol is closed
Bootmanager: not found
Telnet disconected
Telnet login: incorrect
All this found using DCC 2.96
Network : O.K.
FTP: Connected
When try FTP on DCC2.96 left side remain empty
When check settings with Dreamset 236 receiving: Connecting to box fail.Connecting to ftp://.....The password was not allowed.
Any clue or must return to 1.6.6.
- Messages
- 17,545
The image does not have a password its blank.
