Help setup 6 LNB DiSEqC for Sifteam Enigma2 for Cuberevo Mini

H

HardDisk

Registered
Messages
26
My dish DiSEqC setup is as follows using Sifteam DGS firmware

Example for Nilesat:

LNB Type: Univ_LNB
Local Frequency: 9750/10600
TP Frequency 10795/V
LNB Power: ON
22Khz: AUTO
Toneburst: NONE
DiSEqC Parameter: A
Uncommited Switch 1
DiSEqC Repeats: NONE
Swap Command: NO
Sequence Repeat: NO

I have 6 LNB's setup

Nilesat A/1
Eutelsat W3A B/1
Eurobird 9 C/1
Hotbird D/1
Eutelsat W2 A/2
Badr/Eurobird2 B/2

How do I setup this on Sifteam Enigma2? I see only 4 diseqc can be setup together A/B/C/D maximum, please give some detail on how to make all 6 work. Please with some detail if you can.

Thank you in advance from the bottom of my heart
 
S

[email protected]

Registered
Messages
5
Hello HardDisk
I have a ip910 with a 10 way Diseqc switch, i have 5 sat positions and this works great for me, just fill in what i wrote here.
Keep diseqc parameter to A for all positions.
Change uncommited switch to number i wrote below (this is the same as the outputs on your switch)
change swap command to yes for all positions.
Thats it .
Regards :thum:


LNB Type: Univ_LNB
Local Frequency: 9750/10600
TP Frequency 10795/V
LNB Power: ON
22Khz: AUTO
Toneburst: NONE
DiSEqC Parameter: A
Uncommited Switch 1
DiSEqC Repeats: NONE
Swap Command: yes
Sequence Repeat: NO

I have 6 LNB's setup

Nilesat A/1
Eutelsat A/2
Eurobird 9 A/3
Hotbird A/4
Eutelsat A /5
Badr/Eurobird2 A/6
 
H

HardDisk

Registered
Messages
26
All Fixed.

Actually your configuration doesn't work for me, the guys at Sifteam helped me out a lot and got it working since my configuration is a standard D 1.1 with two switches.

Tetra and LLP from forum Sifteam gave me some tips, so this is what I did:

To have standard 4 DiSEqC Switch for fixed LNB's is as follows.

My configuration had to have:
Committed DiSEqC command AA
Uncommitted DiSEqC command Input 1
Committed DiSEqC command AB
Uncommitted DiSEqC command Input 1
Committed DiSEqC command BA
Uncommitted DiSEqC command Input 1
Committed DiSEqC command BB
Uncommitted DiSEqC command Input 1

Then
Committed DiSEqC command AA
Uncommitted DiSEqC command Input 2
Committed DiSEqC command AB
Uncommitted DiSEqC command Input 2

Since my connection is uncommited I changed the order of the commands from:

Command order committed,uncommitted,toneburst
to
Command order uncommitted,committed,toneburst

Response time was fine but for safety measures I set:

Sequence repeat yes
 
You must log in or register to reply here.
Top