Hi
I ve moved to another place where dish(es) are slightly differently setup than it was in my old place.
I ve only changed LNB priority as I now have three instead two satellite dishes.
Problem is as follows:
DM 7020 with Gemini1 4.70 cannot locate approximately 20% of transponders like 12303H 74500 3/4 on 7W
It shows BER and it wont locate them.
This occurs as well if I am using Gemini2 4.40 image on same box.
IMPORTANT NOTE: Transponders that I could not locate with DREAMBOX are above 12 000 MgHz although some above 12 000 MgHz are located
On another side using simple cheap TECHNOSAT with settings on LNB 10600 MgHz instead Universal - it is capable to locate and find all these transponders with same system?
What shall I do - reload satelites.xml or whole settings?
Which one is best? I need 13 E; 26 E and 7W.
I do not have internet yet so I would FTP them if necessary but which tool to use?
Thanks in advance . Any experience is highly appreciated.
I ve moved to another place where dish(es) are slightly differently setup than it was in my old place.
I ve only changed LNB priority as I now have three instead two satellite dishes.
Problem is as follows:
DM 7020 with Gemini1 4.70 cannot locate approximately 20% of transponders like 12303H 74500 3/4 on 7W
It shows BER and it wont locate them.
This occurs as well if I am using Gemini2 4.40 image on same box.
IMPORTANT NOTE: Transponders that I could not locate with DREAMBOX are above 12 000 MgHz although some above 12 000 MgHz are located
On another side using simple cheap TECHNOSAT with settings on LNB 10600 MgHz instead Universal - it is capable to locate and find all these transponders with same system?
What shall I do - reload satelites.xml or whole settings?
Which one is best? I need 13 E; 26 E and 7W.
I do not have internet yet so I would FTP them if necessary but which tool to use?
Thanks in advance . Any experience is highly appreciated.
Last edited: