HELP NEEDED!

[dreamuser]

I have this problem with my satellite system i'am using a disecq motor and Maxdigital XP1000, with pli 2.1 image, the satellites that i can watch are these 28e,19e,13e,7e,4.8e,1w the signal on these satellites is very good about 85-90pct, but when i move to eutelsat 7e i can watch 3-4 channels all the rest of the channels i see {no signal} i checked everything dish, lnb, cable, still no signal but all the other satellites have good signal, anobody has an idea?

 

[frank087234]

Try with another receiver

 

[aliraza63]

I have this problem with my satellite system i'am using a disecq motor and Maxdigital XP1000, with pli 2.1 image, the satellites that i can watch are these 28e,19e,13e,7e,4.8e,1w the signal on these satellites is very good about 85-90pct, but when i move to eutelsat 7e i can watch 3-4 channels all the rest of the channels i see {no signal} i checked everything dish, lnb, cable, still no signal but all the other satellites have good signal, anobody has an idea?

Just few tips may it can work .
1. check that satellite with Single straight cable
2. if there is joint remove it then check
3. Replace the diseqc Switch use any good brand

 

[Ferret]

On the 3 channel you can see what is the signal strength on them.

Not knowing the channels your trying to view and your location makes it hard for us to help you at all.