It came up with the ''err0'' message. It doesn't start - boot and I can't connect it to the pc again so I can try again because it can not get connected to any port.
Err. 0
Tends to happen when it turns off before you have the deco Good on the display.
Forcing the burden of the firm. Indications of Mitega friend to fix the error 0:
1-Conectas Deco PC with a button back off
With a 2-Utils MvisionE + das firm to charge and says that although there is no continuous deco
3-Choose upgrade software, choose the firm you're going to get (a best original), and gives a start
The 4-Utils mvisionE + show "d000", now turns on the deco (BROUGHT Err0 in the display) off and then turn it on again. And this, you should upload (This firing Shutdown and lighting must be done without much later).
If not what it takes to first, keep trying until it caught q.
Although the display says "ERRO 0" if apretamos with both the volume buttons on the deco of the two at a time, we will see that the display says "092" if we make the burden of the firmware using the pulsed although not detect pc connection deco-The firw is introduced without problems, on the computer when the word good, release the buttons on the volume and we will see that starts to climb up to finish F001 and the word "GOOD".