bad solution:Try transferring keys from PC to STB, then you'll have full set....
there is only about Opticum xxx_emu_1.3.08:Try load no key files... but NEW SW (last for example)
And dont forget make a RESET into EMU...
Must be all ok!
there is only about Opticum xxx_emu_1.3.08:
there is all ok until first switch off (power off or stand by)
switch on = again only irdeto keys
or don't switch off :thum:
may have programmer a contract with the distributor of electricity?
yes, i don`t needThe latest softrware is edit so insert with full new keys in tham
you don`t need to put any new keys and you can`t install any softcam by that firmware
yes, i don`t need
but digi au must to insert new active row and this is deleted after next switch on
I have a 4060cx.
I tested "Opticum 4060CX 4160CX_emu_1.3.08 (22.01.2010).rar" - after each power on must reset keys and wait on 0.8W every time.Is not a good solution . Initialy start only with irdeto. I go back to 1.3.07.
i have globo 7010 cr with last emulator 2.4.57 and i see new keys for viacces biss art etc,my question,this keys work on my receiver and open bis,art,srg etc?
how can we return to old soft?when i try to reflash say is too old!thanksI have a 4060cx.
I tested "Opticum 4060CX 4160CX_emu_1.3.08 (22.01.2010).rar" - after each power on must reset keys and wait on 0.8W every time.Is not a good solution . Initialy start only with irdeto. I go back to 1.3.07.
how can we return to old soft?when i try to reflash say is too old!thanks
which sw i can use for this rec
yumatu iq pvr
model id 3329e_pvr
s-w version 04000100-10.45emu
hw version ali-29e-ver2.2
loader version m3329e 1.1.1.
latest update nov 27.2008
stb sn ali 3329e_ali-29e-ver 22 yumatu
stb id 04000100:000d11
how can we return to old soft?when i try to reflash say is too old!thanks