c line oscam
- Thread starter lacierva
- Start date
i'm not getting anything either when trying to connect from a oscam to cccam server was not authorising itself even thou the server is mine so i know all the usr/pas are correct.
But if you have radar installed you can connect to the server with that but not if its running 2.2.1, CCcam2.1.4 is the highest i have had any luck with
But if you have radar installed you can connect to the server with that but not if its running 2.2.1, CCcam2.1.4 is the highest i have had any luck with
bassethound
Registered
- Messages
- 42
Open radar.cfg which is located in var/etc and put your C line(s) under the following section in radar.cfg :
#---------- CCCAM OR GBOX CLIENT LINES --------------#
you can get your C lines from your cccam.cfg file, use notepad or any text editor to do that.
#---------- CCCAM OR GBOX CLIENT LINES --------------#
you can get your C lines from your cccam.cfg file, use notepad or any text editor to do that.
first of all dellete everithing in radar.cfg
i managed to get my C:lines to work using oscam by adding them through the receiver using the remote control (add server).
i added 11 c:lines and all work very well.
you can then go to the oscam.server using Dcc and edit them.
(Var > Oscam > Config > Oscam.server.)
i think the problem is caused by not using a linux compatible editor, for windows.
Oscam is much more stable than Radar.
i added 11 c:lines and all work very well.
you can then go to the oscam.server using Dcc and edit them.
(Var > Oscam > Config > Oscam.server.)
i think the problem is caused by not using a linux compatible editor, for windows.
Oscam is much more stable than Radar.
sherifsurf
Registered
- Messages
- 16
Which OSCAM version you use?
sherifsurf
Registered
- Messages
- 16
Thanks now i have all my card working on the server 
I think it is a must to change the "cccversion" to 2.1.4 like hizach said.
but i have one more question, when zapping the scrambled channels it goes too slow, please find below if i have something wrong or i have to change something in my config file:
[reader]
enable = 1
protocol = cccam
cccmaxhops = 3
blockemm-g = 1
ccckeepalive = 1
label = New Server
emmcache = 1,2,2
user = username
cccversion = 2.1.4
device = domain,port
group = 1
fallback = 1
password = password
I think it is a must to change the "cccversion" to 2.1.4 like hizach said.but i have one more question, when zapping the scrambled channels it goes too slow, please find below if i have something wrong or i have to change something in my config file:
[reader]
enable = 1
protocol = cccam
cccmaxhops = 3
blockemm-g = 1
ccckeepalive = 1
label = New Server
emmcache = 1,2,2
user = username
cccversion = 2.1.4
device = domain,port
group = 1
fallback = 1
password = password