8 x LNB Settings...

[TheReal]

Hello,

I am trying to configure my fathers Dm 800 se clone.
He has 7 LNBs and uses a 8-1 switch.
Are there and pictures of the settings? I know it is under "advanced" but I am not sure after that because right now it works on one (0.8W) and I can go to another satellite if I want (19.2E for example) but after that if I try to go back to 0.8W or other satellite position I get a tuning error.

Anybody with some info?

 

[Ferret]

Take a look at this

http://www.sat-universe.com/showthread.php?t=181704

 

[RimaNTSS]

@TheReal Example: I have 4,8*E LNB connected to second input of the switch. Do the same for each LNB in your 7-LNB setup, it should work for you as it works for me.
https://www.dropbox.com/s/rwm8fipaf6uuviv/ScreenHunter_624 Feb. 16 23.31.jpg?dl=0

 

[TheReal]

Take a look at this

http://www.sat-universe.com/showthread.php?t=181704

I will check it out, thanks. How do I know if I have committed or uncommitted switch?

@TheReal Example: I have 4,8*E LNB connected to second input of the switch. Do the same for each LNB in your 7-LNB setup, it should work for you as it works for me.
https://www.dropbox.com/s/rwm8fipaf6uuviv/ScreenHunter_624 Feb. 16 23.31.jpg?dl=0

Thank you. Only problem is committed and uncommitted et.c, it should be set to "none"? I don't know what the switch function as.

 

[BM300]

Committed is normally used for DiseqC 1.0 type.
It works for ports 1 to 4.
It can also be used on DiseqC 1.1 type but only ports 1-4 will work.

Uncommitted is for DiseqC 1.1 type and above and applies to all ports.​

 

[TheReal]

Committed is normally used for DiseqC 1.0 type.
It works for ports 1 to 4.
It can also be used on DiseqC 1.1 type but only ports 1-4 will work.

Uncommitted is for DiseqC 1.1 type and above and applies to all ports.​

Problem is for my first input it always stays as "committed, uncommitted", I can change it but it does not save it. I have flashed the box 2 times because I thought it was that, but it was not.

 

[BM300]

Problem is for my first input it always stays as "committed, uncommitted", I can change it but it does not save it. I have flashed the box 2 times because I thought it was that, but it was not.

If you specify the DiseqC to be 1.1 and push the OK button it should save the change.

​

 

[TheReal]

If you specify the DiseqC to be 1.1 and push the OK button it should save the change.
​

I know but for some reason it does´t, and it is only for LNB port 1 it does this, very strange. I´ll take a look at it today and see what happens, thanks.

 

[BM300]

Have you tried not using port1?
Start with port 2 onwards​

 

[TheReal]

I fixed it now, seems that I did not save it properly after I exited the settings >_<.