• Discussion in the Admin room about nightly images, we dont really need or want these posting for the following reasons.

    1. We all know where to get them.
    2. Never have a change log.
    3. The changes if any are not worthy of anyone upgrading there boxes on a daily basis.
    4. They clutter the forum up.

    Posts will be removed.

    Ferret

ccamd share

rebelking1980

Registered
Messages
60
hi to everyone!

im about to buy a second hd reciver and i dont want to pay second time to get another username/password from the pay server.

is it possible to connect the recivers through a cardshare protocol (homeserver/sbcl/xshare/sssp/tm share) and the 1st reciver to give the keys to the 2nd reciver through the modem??
i dont want to enter the username/password of the pay server to the 2nd reciver cause double log in will detected and it will block the account.
both recivers are in same house ofcurse connected to the same modem/router.

is posible?
or it works only for the cards in the slot??

thank u...
 

rebelking1980

Registered
Messages
60
it can be done!!

lets say we have 2 ali3602 recivers!

the 1 is conected in internet and has satelite cable!
the 2nd its with a seperate satelite cable but without internet conection.

load the most new ali3602 software/firmare to both of them.
press 9339 to the internet reciver.
choose cardshare/homeserver
connect the 2 recivers using an rs232 cable female to female
or connect as many cables up to 50meters until u connect the 2nd reciver.

press 9339 to the second reciver
(no internet connection in this reciver)
choose cardshare/homeclient1

now both machines can work INDEPENDENT using same card or internet connection
 
Last edited:

rebelking1980

Registered
Messages
60
it can be done!!

lets say we have 2 ali3602 recivers!

the 1 is conected in internet and has satelite cable!
the 2nd its with a seperate satelite cable but without internet conection.

load the most new ali3602 software/firmare to both of them.
press 9339 to the internet reciver.
choose cardshare/homeserver
connect the 2 recivers using an rs232 cable female to female
or connect as many cables up to 50meters until u connect the 2nd reciver.



press 9339 to the second reciver
(no internet connection in this reciver)
choose cardshare/homeclient1

now both machines can work INDEPENDENT using same card or internet connection

both recivers must have same generation chip/cpu and software....
 
Top