DM500 1-4 diseqc plus motor

Hi:-
Looking fo some help.. browsed the forums but can't find the answer.
I had this setup working for over a year until my DM500 froze a couple of days ago and I had to reload using dreamup..
(I did not make an image file)

My setup is as above with diseqc switching with
usuals motor connected to input LNB-0 on diseqc
fixed sat dish pointed to 19deg connected to LNB-1 on diseqc
fixed sat dish pointed to 28(sky) connected to LNB-2 on diseqc
LNB-3 on diseqc not used

I have selected non standard setup up DM500 and set the following
LNB0 to diseqc 1.2 A/A
LNB1 to diseqc 1.2 A/B
LNB2 to diseqc 1.2 B/A

I pointed LNB0(motor) to 13deg and scanned channels
pointed LNB1 to 19deg and scanned channels
pointed LNB2 to 28deg and scanned channels

When I now try to move dish to another position I get the message
Diseqc is enabled on more than one LNB.. plaese select the LNB the motor is connected to

Also everytime I select channels between dishes I get the message
Please wait while motor is turning to (position)
Even though this could be a fixed dish..or motor is already in thet position.

I know at one point there was a tutorial that gave a stepe by step on the setting within DM500 for this as this is what
i used to setup the box before it froze..
don't think I am far out but if anybody could shed any light on where I am going wrong it would be most appreciated..
Thanks.. STUM

Moving

Ferret said:

Try changing the LNB1 & 2 to diseqc 1.0.

If your using Diseqc 1.2 on the output to the motor all position will have to be searched for manually or have you setup gotox?

Ferret

Click to expand...

Thanks.. that was where I was going wrong..