How to do auto-update with ITGATE Control Center
***New Control center must be used from now on.(from ver.2.4)
1) Download and Unzip the file below.
2) Run the ITGATE Control Center.
3) Insert & save IP address in the 'Config' section.
4) Press 'Update' button & select the *.img file in the 'Update' section.
5) Autoupdate will be started.
6) Wait until the receiver reboots automatically
How to update TGS110 with Memory Card automatically
1) Copy all below files(after unzip) inside folder to the memory card.
2) Switch off TGS 110 and insert the memory card into the memory card slot of front panel.
3) Switch on TGS 110 and you can see "doun" on LED display, it means downloading is started.
4) Soon after, you can see downloading process by number(1~100) on LED display. Please wait until it shows "done".
5) After checking "done" on LED display, remove Memory Card and switch off and on again.
6) Update completed!
Warning) Do not remove memory card during reading and writing mermory card in any cases.
How to update TGS 110 by Flashing through serial port
***New Control center must be used from now on.(from ver.2.4)
1) For Serial update, please click hereunder to download the image.
1. Connect the receiver & PC with RS 232 cable
2. Power on the receiver & press up button on the front at the same time repeatedly.
3. You will see the menu,in which there is 'Serial Update' & go to the menu using by up/down button.
4. When you cursor located on 'Serial update', press right button
& Press ok button to start the upgrade.
-----------------------------------------------------
Before the above no.4,
1. run the control centre & go to the 'Serial update' section (you don't need to input IP address)
2. After setup the com port, press 'file' & select the img.file.
After that, you can start the serial update under the above no.4
How to update by Internet
1) Press MENU button on the remote controller and go into " Setup -> Expert Setup -> Software Update -> Internet Update" and select the image.
2) Follow as prompted on the menu..
