Cas 2+ and dragon cam

bledi07

Registered
Messages
28
Hi guys.I have a cas 2+ to update dragon cam.
I bought this cas 3 months ago.
In the bigening to update dragon cam it took me only 7 minutes with cas studio 8.3 but when i started to use cas studio 8.3a is taking 14 minutes to update the cam.
Any sugestion is this the normal time or what am i doing wrong
that is taking so long.
 

dante

Registered
Messages
44
with cas interface studio 4.7.1 program for 2 min..

here download the program..
XXXXXXXXXXXXXXx

No link for other forum or upload
edit: k@lkov
 
Last edited by a moderator:

Glenn_911

VIP
Messages
674
Hi guys.I have a cas 2+ to update dragon cam.
I bought this cas 3 months ago.
In the bigening to update dragon cam it took me only 7 minutes with cas studio 8.3 but when i started to use cas studio 8.3a is taking 14 minutes to update the cam.
Any sugestion is this the normal time or what am i doing wrong
that is taking so long.

bledi

It takes me only a few min to write the Dra Bin, think your PC is slow or you got some problems with virus.

Glenn_911
 

bledi07

Registered
Messages
28
with cas interface studio 4.7.1 program for 2 min..

here download the program..
XXXXXXXXXXXXXXx

No link for other forum or upload
edit: k@lkov

Are you sure about this old version.Is not in duolabs official site.Does it work
 

milo2006

Registered
Messages
10
bledi

It takes me only a few min to write the Dra Bin, think your PC is slow or you got some problems with virus.

Glenn_911

Hi Glen_911;

I was asking this question in several forums and didnt get the answer yet.

Here it is:

I want to format my T-Rex cam. I am having CAS Interface 2+ programmer. I tried to update the firmware but I am getting always CI module error even though everything is connected correctly.
 
Top