How to flash a Technomate TM-Nano 2 Super.
1. Format a USB stick to FAT32
2. Download the image of your choice and extract it to your desktop.
3. Open the folder you extracted to your desktop, you will see another folder named update, this is your image file.
4. Copy the entire update folder directly to the USB stick.
Make sure that your receiver is connected to your TV as the TM-Nano 2 Super does not have a display, and you wont see the prompt to update the software otherwise.
Flashing the Receiver.
– Fully power the receiver down via the rocker switch at the rear of the receiver.
– Make sure no USB devices are plugged into the receiver at this point.
– Insert the USB stick containing the image files into the USB port on the receiver.
– Power the receiver on from the rear rocker switch.
As your TM-NANO 2 Super starts to power up you should see a prompt on your TV screen asking you to press the ok button to update the software, at this point you need to press the ok button on the front of the receiver to initiate the flash / update procedure..
If you dont see the prompt to press the ok button but instead see the message “starting” it means that the receiver has not detected the USB stick or image files or both. If this happens start from the beginning or try another USB stick, Image or USB port on the receiver.
If all goes well the flashing process should take approximately 2 to 4 minutes to complete, you should now see a message on your TV screen telling you to remove the USB stick and reboot the receiver. Only at this point should you power the receiver off then back on again to reboot the box.