CAS3 plus not recognising any CAM

change your USB cable on your XP pc ...recoqnising?
another COM port (use 1-4)...try it ... ok?

with Win7 are problems for this program CAS3+
but it must working good in XP...
can you try back to a older version of CAS Studio?

no blocking on your V-checker?... stop this for try

grtz r-sixx

r-sixx said:

with Win7 are problems for this program CAS3+
but it must working good in XP...
can you try back to a older version of CAS Studio?

no blocking on your V-checker?... stop this for try

grtz r-sixx

Click to expand...

Have tried already with other cables. In matrix section the cam is identified but after writing it doesn' initialize in CI-Host of cas studio and in the receiver as well. After writing i push on verify and it shows up many read errors

check pins (contacts) if any bent, broken or slid into CAS

dxdy said:

check pins (contacts) if any bent, broken or slid into CAS

Click to expand...

Already checked, seem to be ok not bent. But the strange is that on the 2nd range of pins the 2nd pin from left and the 2nd from right are little bit shorter. Is this normal? The cas3+ is 2-3 months old and not a lot used for ci programming.

by mine cas 3 the pins you describe are also shorter but works fine now.the problem i had that it was connected to a seperate
usb host and also had problems.try directly connect the cas to
usb port of your computer.

You can return a year ago the timer of computer and ok

Unfortunately i have already tryed on other usb ports, reinstalling cas studio (even older version) and trying to programm with use of other pc (windows xp) but always the same dead point

Cas studio 8.7 its not working at the moment.

set the Date Back and its working

soon a new version ???