vModules (tandberg, viaccess, ect) for vPlug , NWemu , MDPlug , vPlug Server

Status
Not open for further replies.

dahaka

Registered
Messages
700
vModules updated for vPlug , NWemu , MDPlug , vPlug Server

To be update each new Module , any one got new mdl please update the topic and attach here .

1. Viaccess.1.6(30-06-2014).mdl, Version: V 1.6, Author: jodete Atlas HD100
2. Drecrypt.mdl, Version: 10/07/2014, Author: DebugProcess
3. Tandberg.mdl, Version: V 1.1 01/07/2016 , Author: SPC


Code:
Loaded module: Cryptoworks.mdl, Version: V 1.3, Author: SPC
Loaded module: Drecrypt.mdl, Version: 10/07/2014, Author: DebugProcess
Loaded module: Irdeto.mdl, Version: V 1.1, Author: V
Loaded module: nagra.mdl, Version: V 1.8, Author: V
Loaded module: ***.mdl, Version: V 1.1, Author: V
Loaded module: Seca.mdl, Version: V 1.3, Author: V
Loaded module: Tandberg.mdl, Version: V 1.1, Author: SPC
Loaded module: Viaccess.1.6(30-06-2014).mdl, Version: V 1.6, Author: jodete Atlas HD100
 
O

ooOO_SORGOS_OOoo

IMPORTANT INFO


ACTIVE MDL I THINK,
*N-D-S
*VIACCESS
*TANDBERG
*IRDETO ACTIVE MDL I THINK

DRECRYPT.MDL NOT WORK
CRYPTOWORKS DOWN ALL CHANNELS
POWERVU.MDL - < I AM NOT SUCCES-I AM USING POWERVU EMU V2,3
SECA NOT ACTIVE KEYS
NAGRA.MDL NOT ACTIVE SAT CHANNELS KEYS

DONT DELL THIS MESSAGE

THANK YOU
 
Last edited:

EnoSat

Senior Member
Messages
1,952
Enosat hello
You must write here details
Sat,frequences and other details

Other friends
This topic not chat

update your Important info and delete messages
0_D00_last.png
 
Last edited:
O

ooOO_SORGOS_OOoo

Tandberg.mdl V1.3.1


This is the new `bin\.mdl` file for vPlug (+ full source code) and supports the new nanoEC. You should copy it to vModules folder.
Notes: It requires a DES key and also an AES key (included too, in the bin folder). Without these `2 keys`, it won't work.

So ...
- Good news: we know how nanoEC works.
- Bad news: It requires 2 keys. 1 DES key and 1 of 32 AES keys which won't be transmitted by the EMMs.

Based on the posted image, AES keys start from index 01 to 20 and not 00 to 1F. Use the attached file.
 
Status
Not open for further replies.
Top