EDISION TROJAN BOOT PROBLEM!! SOS!!!!

L

LordOfRings

Registered
Messages
3
hi guys ,

I have a big problem!! I have an edision trojan receiver and before few minutes I tried to install a new firmware .. .

The result was that my receiver never started ...

it says in little screen OK and nothing on tv . .. It crashes in boot.

Is there any solution ? I tried the setedit but it can be connected ..

thank you in advance.
 
J

*Joker*

Registered
Messages
108
It is only one solution possible:

Please use STB erom upgrade 2.0.a

Use RS232
Switch Trojan off, start the tool and then switch on, please make this 10-15 times until the Box will boot

Sorry, i cannot load the tool here in thread...:confused:
 
E

enosi

Registered
Messages
1
I tried load new firmware and the decoder crashed.
The led screen shows ASH and the decoder doesn' t boot.
I tried the update tool but nothing
what should i do? have anyone to suggest soething else?
 
You must log in or register to reply here.
Top