Samsung Dsr9500 EMU Rv Gold v4.0

1) Samsung DSR 9500 VIA CI [HW 504, NOT FOR Loader 500 for now, JUSR for Loader 501] on Standby
2) Connect to the PC via straight serial cable
3) Start Samsung DSR Studio 1.0 Editor by MAHDI
4) Choose FW Loader TAB
5) Choose Serial Port
6) Click on Send FW and then choose which EMU [and it's away, racing...]
7) Wait untill you see the clock on Sammy Display
8) Start Sammy [on FTA channel, just in case], check it, then put it on Standby
9) Click on RAM Editor Tab in the Samsung DSR 9500 Studio Editor by MAHDI
10) Choose Serial Port, then Open File, then click on Write and wait for the clock again
11) You'll see "Insert smartcard" message, then re-start Sammy
12) At this point I would [and I am going to]
Menu -> Channel organising -> Delete all channels and then
Menu -> Installation -> Manual Scanning and do your own settings list
13) Experiment with various cards
14) Sort out the GBox and Card Sharing bits...

Mahdi, m8, a suggestion:
We could do with a bit of an editor/controls of all the CS options [2 pieces of SW]. Both as a Server via a programmer in the Phoenix mode and as a Client.
THANKING YOOOOOUUUUUUUUUUUUUUUUUUUUUUU!!!!!!!!!!!!!!!
MAHDI FOR PRESIDENT!!!

Thanx to RAUL:

everything works fine here ,

dummy card is not needed anymore .

0+menu brings up the emu/key settings .

biss/static dw format has changed , last two bytes of pmt/pcr required
instead of both pmt bytes like before .

dsr studio/editor works fine .

Click to expand...

:thum: :clapping:

WARNING

The new emu works only with loader 501.
If you don't have loader 501 - DONT USE THIS EMU!

If you have loader 500: First must be made an flash dump from loader 500 to 501.



DSR9500 added subtitle

To warn members I've added/changed subtitle

Advise: Don't try this firmware unless you are sure to have bootloader 501 !

Bus as we now have version 4.2, this thread better be removed from forum !