for funcard (Humax5400 EEPROM Editor)

Status
Not open for further replies.

Darkmoon

Senior Member
Messages
320
77485494b5e66546c8.gif


Code:
Features:

- Reading and writing a Fun-EEPROM without a programmer (Mode 0)
  (You have to use an Xin1-FUN in the internal CAM and
   the IRCI 5400 must be connected with your PC over RS232)
  You have to edit the HEE.INI file for your COM settings.

- Automatic Web Update 
  With this function you can read web sites with key data and write
  it to the fun. Before you can use this function, you have to use
  "Read all" once to get a base file.
  The files *.HEE contain the commands to analysize the web sizes.
  You can define your own scriptfiles for other web sites.
  
- Under WinXP you can install it as a service, with
  HEE -install
  you can remove it with
  HEE -remove
  If you want to use more than one service, you only have to rename
  the files before installing the service.
  (for example HEE1.exe, HEE1.ini, HEE1.bin)

- Remote Activation from Humax
  You can start the key update with the following buttons on the
  remote control:
  9 RCL WHITE WHITE EXIT

THANKS ELAHMED
 
Last edited:

Darkmoon

Senior Member
Messages
320
77485494b60db9b268.gif


ISVEdit version 2.3

Code:
- new config setting

Code:
With this editor you can read and write directly
to the card with a Phoenix.
Also all keys and settings can be edit.
Suports .hex, .bin and .crd format.

note: all Versions higher than 2.3 or only patched older versions of ISVEdit


THANKS ATEF2003
 
Status
Not open for further replies.
Top