whats best stable E2 image for ipbox 9000hd

[cybercypher]

hi guys,
just a quick one
I have been playing around with my ipbox 9000hd and was wondering whats the best stable image to install on it.

I don't want to keep getting the green crash screen

thanks for any comments

[mbd]

e2 = hdmu install on usb.
dgs = pgi 1.5 install as flash.

[cybercypher]

thanks I will have a look at them.
can/do any of these have card sharing capabilities like cccam

[mbd]

yes = cccam mgcamd oscam.

[charli82]

very nice

[pbieg]

I have PKT Hyperion 5.1 with memory cleaner , it works well

[cybercypher]

thanks for all your replies

my next question is can anyone help me on how to flash the image?
I know how to flash the image using flash tools.
but I don't know how to flash using the usb stick which show all the files. (if that make sense)

I know I need to ftp them to the ipbox but how do I find the ip address.

or is there anyone local to Doncaster that can help me out?
by showing me where im going wrong

thanks guys

[mbd]

FLASHING.
D.L file.[ flash ver] extract and rename usb_update.img
format dok fat32 and transfer file .
disconnect box from power' and connect dok hold power button and
reconnect box when "usb update" come on release the power button and
wait until "done" come up.disconnect dok and restart the box.
that's how u flash a box.

[olep]

1. Boot your DGS image, wait to full boot.
2. Insert your USB stick
3. Telnet to your box, execute mount
4. In the list check - if the /dev/sdb1 is mounted (if is FAT probably is mounted to /mnt/usb/usb0)
5. umount it - umount /mnt/usb/usb0
6. now execute fdisk /dev/sdb (not sdb1)
7. on the prompt press p - to see current partition table
8. press d - to delete partitions, if it is only one proceed, if not - press d again and delete all partitons
9. press p again - there will be no partitons now
10. Press n - to create new partition
11. select p - primary
12. select 1
13. press enter, enter (or the last default sector-number)
14. press w to write changes & exit
15. You have just created linux partition on your usb stick
16. Now format this partition - mkfs.ext2 /dev/sdb1
17. mount formatted partition again - mount -t ext2 /dev/sdb1 /mnt/usb/usb0
18. Now ftp e2 tar.gz to /mnt/usb/usb0
19. execute cd /mnt/usb/usb0
20. execute tar -zxvf 9000.tar.gz, wait few minutes to decompress all. (wait for prompt)
21. after decompress type, sync


to unmount just

cd /
umount /dev/sdb1

Last, a hard reset and wait 30 sec.
This must work, press 2 or 3 on your remote for 5 sec before booting.
I just copied an experts advice and added a few small things.
Succes.

[cybercypher]

still cant sort this stupid box out
been at it for a week now and still no further forward.