Convert ird Card to Coco mcr
I think that conversion is possible. I try to use well-known kill ir2-ok.exe for abracadabra card and result was :"card updated success". But after putting card to fte receiver "abracadabra card detected " appeared (not coco mcr), ofcourse everything working fine but strange ATR. By other side when iI try to same exe
to regular ird2 card answer was "card not updated,check card,bad ATR).With 6 Mhz phoenix it's works OK but ATR was not changed.
CoCo Card du 26/27 02 2009
ATR: 3B 9F 21 0E 49 52 44 45 54 4F 20 41 43 53 20 56 34 2E 31 9D
myATR: 3B 9F 21 0E 49 52 44 45 54 4F 20 41 43 53 20 56 35 2E 37 9A
GAMMA CARD ........... ATR: 3B9F210E49524445544F204143532056 342E319D 4.1
7272C WHITE .......... ATR: 3B9F210E49524445544F204143532056 352E339E 5.3
gamma - 342E319D --4.1
co co mcr - 352E339E --5.3
my atr - 352E379A -- 5.7
---------------------------------------------------------------------------------Trying to reset card...
Reset Successful
ATR: 3B 9F 21 0E 49 52 44 45 54 4F 20 41 43 53 20 56 35 2E 37 9A
Convention: DIRECT
Protocol: T=14
TA1 = 21
TCK = 9A Calculated TCK = 9A
Historical Bytes: 49 52 44 45 54 4F 20 41 43 53 20 56 35 2E 37
I R D E T O A C S V 5 . 7
Programming Voltage = 0.0 volts
Programming Current = 25ma
Maximum Clock Frequency = 6.0MHz
Assuming a 3.5790MHz clock:
Work ETU = 0.0001559095 seconds
Guard Time = 0.0018709137 seconds
Baud Rate After Reset = 6414
Unfortunately I can't recompile coco.exe I think there need some tool to change ATR last byte, meant 79->39(ASC5.7toASC5.3)or hex editing updated exe.Unfortunately I can't post screenshots but
when I put card to my FTEMAX receiver it looks like coco mcr.
Again last thing to update. Any ideas?