Hello everyone, I have a cam Unicam 4.0 on my DM8000 and I installed the new firmware 04.22.1021 (link). In reference to this post I would like to ask some questions:
1) What is the difference between the file Pacific and the Troja?
2) I now have a card 09cd of S*Y ITA with error 999x: doing a reset cam, I can remove the error and retry the activation? I do not know the pin numbers 4: Is it 1234??
3) In the case could not remove this error and decide to take a new card, can you show me how I have to set the parameters of the cam so I avoid the error?
-------------------------------------------------- ---------
Setting -> Smart CardCam Settings ->
Force Irdeto: Yes
Force Nagra: Yes
*** FastMode +: Yes
Card Allcam: Yes
Prevent S*y DE Marr**ge: Yes
EMM-UA Blocker: Yes
EMM-SA Blocker: Yes
EMM-GA Blocker: Yes
-------------------------------------------------- ---------
During activation of the card (card inserted into the cam and cam inserted on the decoder) but I have to leave so only
EMM-UA Blocker: No
So I get only the len/ins of my card and not the ones that cause me the error 999x. It's correct or no? Once activated the card so I have to leave
EMM-UA Blocker: No
to receive updates or do I have to put it
EMM-UA Blocker: Yes
Help me to understand how best to configure the cam?
Thank You
:thum:
1) What is the difference between the file Pacific and the Troja?
2) I now have a card 09cd of S*Y ITA with error 999x: doing a reset cam, I can remove the error and retry the activation? I do not know the pin numbers 4: Is it 1234??
3) In the case could not remove this error and decide to take a new card, can you show me how I have to set the parameters of the cam so I avoid the error?
-------------------------------------------------- ---------
Setting -> Smart CardCam Settings ->
Force Irdeto: Yes
Force Nagra: Yes
*** FastMode +: Yes
Card Allcam: Yes
Prevent S*y DE Marr**ge: Yes
EMM-UA Blocker: Yes
EMM-SA Blocker: Yes
EMM-GA Blocker: Yes
-------------------------------------------------- ---------
During activation of the card (card inserted into the cam and cam inserted on the decoder) but I have to leave so only
EMM-UA Blocker: No
So I get only the len/ins of my card and not the ones that cause me the error 999x. It's correct or no? Once activated the card so I have to leave
EMM-UA Blocker: No
to receive updates or do I have to put it
EMM-UA Blocker: Yes
Help me to understand how best to configure the cam?
Thank You
:thum:
Last edited: